I machined the kickstand tab off today, used an air grinder with a sanding tab to get it down further until I was able to pull it off. Next I will cut a piece of flat aluminum and slide it inside of the swingarm under the holes and have it filled with weld and smoothed off then Powder Coated.
Swingarm Tab GONE!!!
-
- Member
- Posts: 264
- Joined: 12:15 pm Jan 19 2008
- Country:
- Location: York, PA
- radonc73
- Gold Member
- Posts: 574
- Joined: 01:45 pm Nov 03 2006
- Country:
- Location: NW Indiana
- Contact:
-
- Member
- Posts: 264
- Joined: 12:15 pm Jan 19 2008
- Country:
- Location: York, PA
I had it welded today, used the threaded plugs that were part of the kickstand tab to weld it shut. Next I am going to sandblast it and have it powdercoated. Turned out good so far.
IMG]http://i34.photobucket.com/albums/d139/ ... MG2934.jpg[/IMG]
IMG]http://i34.photobucket.com/albums/d139/ ... MG2934.jpg[/IMG]
- zombiescustoms
- Member
- Posts: 43
- Joined: 08:39 pm Dec 22 2008
- Country:
-
- Member
- Posts: 264
- Joined: 12:15 pm Jan 19 2008
- Country:
- Location: York, PA