This is what I've lately. All new bearings, rod, seals on bottom. New top end, honed cylinder, cleaned pv completely. Went thru the Carb, cleaned real good put new jets, set float (which I seem to have trouble with on the pwks for some reason. It never seems right. But it does not leak out over flow either.
Current jetting. 40 PJ, 155 mj, floats at 16mm, 1174 needle at 3rd clip. #5 slide. As1.5 out. B7es plug. I'm at loss on this now.....also timing mark is set at most CCW mark or the furthest to the left. Is this advanced or retarded? Please throw suggestions guys,