Another kips question
-
- Member
- Posts: 11
- Joined: 08:23 am May 08 2011
- Country:
- Location: ky
Another kips question
I have a 95 kdx 200. I took the slotted cover off to expose the kips shaft. It turns freely with a nut driver but when I start the bike it seems like the shaft rotates 1/4 turn when i rev the bike. I'm pretty sure it's opening all the way just not returning all the way. I dont know anything about these bikes, any help is greatly appreciated.
- Slick_Nick
- Supporting Member
- Posts: 1675
- Joined: 10:06 pm Oct 22 2009
- Country: Canada
- Location: Calgary, Alberta
- Contact:
- Coop
- Supporting Member
- Posts: 180
- Joined: 03:52 pm Sep 24 2010
- Country:
- Location: Acme, PA
Well if you are going to tear it down to clean the powervalves, you might as well inspect the cylinder, inspect/measure the piston (replace if close to limits), replace the rings, wristpin bearing, circlips, gaskets, etc. You have to pull the cylinder to do the valves.
"Twenty years from now, you will be more disappointed by the things that you didn't do than by the ones you did do" - Mark Twain
2003 KDX200
2003 KDX200