According to my cyclepedia manual it says to torque the 4 jug nuts to 18 ft lbs using a crows foot on the torque wrench. My question is, is this calculating for the crows foot because when torquing with a crows foot it changes force point (sorry I do not know correct term for this) or will I need to recalculate? Thanks for the help just want to do it right the first time
Sent from my SM-S920L using Tapatalk
Torque Specs?
- KDXGarage
- KDXRider.net
- Posts: 14062
- Joined: 06:45 am Nov 01 2004
- Country: United States of America
- Location: AL, USA
- Contact:
Re: Torque Specs?
You may want to look at the Motion Pro torque adapter
I think the key is that it is at a right angle.
I think the key is that it is at a right angle.
Thank you for participating on kdxrider.net.
To post pictures from a device: viewtopic.php?f=88&t=24128
To post pictures from a device: viewtopic.php?f=88&t=24128
-
- Member
- Posts: 99
- Joined: 11:48 am Feb 11 2014
- Country:
Re: Torque Specs?
I use the Motion Pro adapter and yes the key is to have it at a right angle relative to your torque wrench then you do not have to make calculations.