you know something.........i got to reading your smartass remark again, and noticed this..................you said that i couldnt tell from a pic what the cylinder look like, but yet you turned right around and said the bore looks wore?????damn???? .......if you knew ANYTHING about motors, you would know pisting slap is from clearance, put a forged piston in there, and you wont have piston slap......... btw, only cast piston breaks the skits like that, they are WWWWEEAAKKK!juliend wrote:lol. "just trust me"??
Did you sneak over there and mic his bore when we weren't looking? If not, it's pretty impressive if you can look at a fuzzy photo of a cylinder on the internet and say "hmmm... yep, that's worn out just about right for a wiseco"
Um, no. Not buying.
Hard to tell from the pics, but the bore looks worn. Have it measured before you go slapping a new top end in it. Excessive cylinder to piston clearance leads to piston slap, worn skirts, and eventually premature failure. I doubt kdxmaniac will foot the bill for those repairs simply because you chose to trust him.
and to tydev95..........have you done anything on your bike yet?