Question about 1-1/8" bar mounts

Got questions? We got answers....
Post Reply
Ipaman
Member
Posts: 76
Joined: 08:54 pm Jul 16 2010
Country:
Location: Nashville, TN

Question about 1-1/8" bar mounts

Post by Ipaman »

I ordered some 1-1/8 bar mounts and since I didn't want to raise the bars any higher I got the kind with the studs so I could replace the stock bar mounts. Well the ones I got seem to have a slightly larger diameter stud than stock. I figured I could just dril out the hole to make them work. Anyone ever do this? Is there a reason this would be a problem?
Ipaman
Member
Posts: 76
Joined: 08:54 pm Jul 16 2010
Country:
Location: Nashville, TN

Post by Ipaman »

Well after removing the stock mounts, I realized my new mounts fit right in. :supz:
Post Reply