Page 1 of 1
Emmig's Clamps.
Posted: 05:17 pm Jun 06 2005
by jafo
Well I took my lower KDX clamp down to Emmig today and he's going to swap the stem into a set of his clamps. He should also be done with my forks also, so I'm almost there. Should have it all together tomorrow night bar any problems.
Jon.
Posted: 08:46 pm Jun 06 2005
by KDXer
My Emig top clamp hits on my tank so I got the heat gun out and modified the tank to clear, not sure about the bottom clamp though... Good luck buddy....
Posted: 09:25 pm Jun 06 2005
by jafo
OK, I think I remember you saying something about that. I went to thier shop today and we took a look at what would work. Basically I'm getting a lower clamp for a kX 250 and a top clamp for a KX 500. They came to this because of the stem size. He's going to do some measureing of the stem and said he may have to add a washer at the bottom between the clamp and lower bearing to get the right length. So we'll see what happens.
Jon.