Emmig's Clamps.

Got questions? We got answers....
Post Reply
jafo
Supporting Member III
Supporting Member III
Posts: 835
Joined: 09:17 am Nov 20 2004
Country:

Emmig's Clamps.

Post by jafo »

Well I took my lower KDX clamp down to Emmig today and he's going to swap the stem into a set of his clamps. He should also be done with my forks also, so I'm almost there. Should have it all together tomorrow night bar any problems.

Jon.
User avatar
KDXer
Supporting Member
Posts: 2845
Joined: 12:11 pm Nov 12 2004
Country:
Location: Sydney, Downunder

Post by KDXer »

My Emig top clamp hits on my tank so I got the heat gun out and modified the tank to clear, not sure about the bottom clamp though... Good luck buddy....
Image

"I want to die peacefully in my sleep like my grandfather, not screaming in terror like the passengers in his car."
jafo
Supporting Member III
Supporting Member III
Posts: 835
Joined: 09:17 am Nov 20 2004
Country:

Post by jafo »

OK, I think I remember you saying something about that. I went to thier shop today and we took a look at what would work. Basically I'm getting a lower clamp for a kX 250 and a top clamp for a KX 500. They came to this because of the stem size. He's going to do some measureing of the stem and said he may have to add a washer at the bottom between the clamp and lower bearing to get the right length. So we'll see what happens.

Jon.
Post Reply