Parts list?
- SS109
- KDXRider.net
- Posts: 5799
- Joined: 05:11 am Aug 23 2009
- Country: USA
- Location: Tucson, AZ, USA
- Contact:
Parts list?
Does anyone have a parts list on what parts should be replaced and what should be checked for replacement when doing a top and lower rebuild? Yes, I have the manual but I would like a simple and easy to read list if possible. Thanks.
Youtube Channel: WildAzzRacing
AZ State Parks & Trails OHV Ambassador - Trail Riders of Southern AZ
Current KDX: '98 KDX220
Old KDX: '90 KDX200 -White/Blue
'11 GasGas EC250R
AZ State Parks & Trails OHV Ambassador - Trail Riders of Southern AZ
Current KDX: '98 KDX220
Old KDX: '90 KDX200 -White/Blue
'11 GasGas EC250R
- Julien D
- KDXRider.net
- Posts: 5858
- Joined: 07:53 pm Nov 07 2008
- Country: USA
- Contact:
It's a 2 stroke. Not a lot of parts in the top and bottom as far as a standard top and bottom rebuild goes.
piston kit (piston, rings, wrist pin)
rod kit (connecting rod, wrist pin bearing, big end bearing)
main bearings
crank seals
Compare that to a 4 stroke top and bottom, LOL!
You'll obviously want to check the cylinder bore, and inspect the KIPS valves.
Of course you'll need a complete gasket set. While you're in there might as well pull bearings from the tranny and match them up for replacement too. No , I do not have the item numbers for them. I just pulled them out and took them to the shop and got replacements.
piston kit (piston, rings, wrist pin)
rod kit (connecting rod, wrist pin bearing, big end bearing)
main bearings
crank seals
Compare that to a 4 stroke top and bottom, LOL!
You'll obviously want to check the cylinder bore, and inspect the KIPS valves.
Of course you'll need a complete gasket set. While you're in there might as well pull bearings from the tranny and match them up for replacement too. No , I do not have the item numbers for them. I just pulled them out and took them to the shop and got replacements.