Page 1 of 1
wrist pin dimensions?
Posted: 05:08 pm Jan 10 2010
by kevfort19
can someone mesure the diameter and the lenght in mm of the wiseco wrist pin... i ordered one and it's not the good one...but it's the good number on the package..
Posted: 11:35 pm Jan 10 2010
by bronco95tgp
Sorry kevfort first ruler I found is in inches..
the pin I got for my 220 is 2 1/4 inches
Posted: 02:20 am Jan 11 2010
by Mr. Wibbens
The good one?
Is there a bad one?
Posted: 07:43 am Jan 11 2010
by Julien D
Right? A wiseco wrist pin is a wiseco wrist pin. If it's gonna fit the wiseco piston it would HAVE to be the correct length and diameter. If there is a good one and a bad one, they would still have to be the same dimensions.
Posted: 08:16 am Jan 11 2010
by kevfort19
wiseco send me a package written 16mm x 2.3 inch.... and i received a wrist pin with a diameter of 20mm and a length of 2 3/4inch. soooo it's not the good. But the number on the bad that is s259 is the good wiseco number for the kdx 220. and yes the package was totaly sealed
Posted: 08:36 am Jan 11 2010
by Julien D
Aha. So it's not that it's "not the good part", but it's the WRONG part. Give them a call, they'll straighten it out for ya.
Posted: 12:59 pm Jan 11 2010
by Mr. Wibbens
fuggin canooks
Posted: 01:31 pm Jan 11 2010
by kdxquebec
Don't mess with canooks.
Posted: 03:31 pm Jan 11 2010
by canyncarvr
There WAS a run of 'bad' Wiseco wrist pins that were the CORRECT part number a few years back. They were a tad too long..the clips could not 'snap' into place.
...and those unsnapped pins came out.
That apparently doesn't apply to this situation.....
Hey! I'm just here for the Kbeq's beaver shot.
Well...his shot of someone else's beaver I'm sure.
Posted: 10:10 pm Jan 12 2010
by kevfort19
lol