KDXRIDER.NET

Hi, anyone got this problem of while tightening the front axle, the speedo meter pick up turns at the same time.
I have checked the placement of the meter to the hub and the meter slot to the fork knob. the torque just force the meter pass the fork knob.

anybody can me with this? just for infor, I did tighten the axle first before going to the 4 pinch nuts.

Hi all, I need help...problem tightening my front axle without having the meter housing turning at the same time.

How can I overcome this?

Anyone?

Bump.

Clean the housing and the axle (use some emery cloth or fine wet-n-dry to remove corrosion from the axle)..lightly grease it before assembly. That will reduce drag between the two.

There is a slot in the housing that fits with a boss on the fork that key the two together and keep the drive from turning.

I'm misunderstanding something....can't say as I understand the problem.

Tks guys, will try out the method. kinda getting fustrasted over it. think it is a design flaw.