Page 1 of 1
Ehaust O-Rings
Posted: 09:51 am Oct 09 2009
by Byte
spec stock is 39mm.
i remember reading somewhere that different size O-Rings may be better.
what is this size and the spec (Higher temp, etc)??
byte
Posted: 10:25 am Oct 09 2009
by Byte
Can a Pipe Torque Spacer fit the KDX220?
Byte
Posted: 12:13 pm Oct 09 2009
by Colorado Mike
you don't need a torque spacer. But yes, it would fit since the pipes are the same.
Posted: 01:54 pm Oct 09 2009
by Julien D
please stop making new threads. Pretty soon we'll be looking at page 2 just to find a thread not started by Byte...
It's perfectly acceptable to ask more than one question in a single thread.....
Posted: 04:45 pm Oct 09 2009
by kdxquebec
Oh! Juliend...So you don't know about the new ''poster of the month contest'' ?
Posted: 05:06 pm Oct 09 2009
by Byte
juliend wrote:please stop making new threads. Pretty soon we'll be looking at page 2 just to find a thread not started by Byte...
It's perfectly acceptable to ask more than one question in a single thread.....
no probs
Posted: 07:04 am Oct 10 2009
by Julien D
LOL! No, I wasn't aware... carry on!
No offense intended, btw.
Posted: 05:19 pm Oct 10 2009
by Byte
no worries juliend.
everyone's input is admired and i understand your concerns...
byte