Page 1 of 1
Header Pipe Bracket - KDX220
Posted: 03:50 am Oct 09 2009
by Byte
I have learned that my KDX220 does not have a header Pipe Bracket. Should there be one as stock? IF not, what after market part do you recommend I use?
Byte
Posted: 06:04 am Oct 09 2009
by Julien D
I am not familiar with a header pipe bracket...
Posted: 06:19 am Oct 09 2009
by Indawoods
Should just have 2 springs holding it onto the jug ... and 2 mounts to the frame. Anything more or less is not common.
Posted: 06:24 am Oct 09 2009
by Byte
Cast into jug, I see 2 threaded holes 180 degrees apart more or less that appears like it holds a bracket similar to the one shown in this link...
http://trailtech.net/flange_protector.html
Sorry - the correct terminology is flanger protector.
THoughts?
Byte
Posted: 06:34 am Oct 09 2009
by Indawoods
You have no springs?
Posted: 06:39 am Oct 09 2009
by Byte
yes 2 x springs.
But also see 2 holes (1 hole each about 1" apart from where the srping hole is).
THese holes are machined and not damaged..
Byte
Posted: 06:40 am Oct 09 2009
by Indawoods
Don't worry about those....
Posted: 06:41 am Oct 09 2009
by Byte
what are they?
Posted: 06:46 am Oct 09 2009
by Indawoods
KDX history lesson...
KDX's are distributed all over the world. Other countries KDX's are slightly different. Some use those... yours don't.