Page 1 of 1
miniumum # of clutch shims
Posted: 10:23 am May 31 2009
by kdx633
02 220 original clutch.Shifting starting to get "notchy". lever angle 65 to 70 degrees.I pulled cover and found only 1 shim on actuator. Manual suggest's up to 2 shims may be added but does not specify if any must used.Any one else familiar with this have a suggestion
Posted: 09:20 am Jun 01 2009
by fuzzy
Notchy feeling generally comes from grooving on the clutch basket fingers...Where the tangs of the discs meet the basket. You can file them to clean it up a bit...If you're not doing clutch job, put plates back in the same way they came out.
Posted: 01:46 pm Jun 03 2009
by canyncarvr
1. What fuzzy said.
2. None must be used. I don't use one.
How do you propose FEWER shims (reduced effective pack thickness) to help?