Alright, I am new here, but not a newby to forums. This seems like a typical newby question to me. However, I have searched for the last 3 hours with no luck. I'm sorry if this has been discussed.
I am rebuilding my kdx. I bought the bike several years ago and the motor was already disassembled. I am uncertain of the correct way to install the valves for the right timing. Remember this is a 94 KDX 200. I have found plenty of info on the new bikes, just not for mine. I know I should probably buy a manual, but this is the only time I would need it is for these kips valves, and plus I may not have the bike for very long.
Thanks for any help you can give me
94 kdx 200 kips timing
-
- Member
- Posts: 29
- Joined: 12:18 am Apr 09 2009
- Country:
- Location: Hamilton, Ohio
94 kdx 200 kips timing
4x4fab.com
- Mr. Wibbens
- KDXRider.net
- Posts: 4884
- Joined: 02:57 am Nov 07 2004
- Country:
- Location: Playing in the Poison Oak
- Contact:
Even with the manual, it was tricky as I recall...
Not gonna have the bike long?
Good luck
Not gonna have the bike long?
Good luck
Warning! This member tends to use sarcasm as a regular form of communication. If a post seems offensive, before you panic and fly off the handle, re-read the post and imagine it being said with a sideways grin.
((Bike Profile))
((Pics))
FIVE OUT OF FOUR PEOPLE DONUT UNDERSTAND FRACTIONS
((Bike Profile))
((Pics))
FIVE OUT OF FOUR PEOPLE DONUT UNDERSTAND FRACTIONS
-
- Member
- Posts: 29
- Joined: 12:18 am Apr 09 2009
- Country:
- Location: Hamilton, Ohio
Yeah. I am completely rebuilding the bike. New bearings everywhere, new rod bearings, top end, kips valves, painting the frame, polished the swingarm, etc etc .... I'll probably ride this bike for 9-12 months when I plan to uprgrade. I'll likely buy a newer kdx or possibly a crf250x.
Really wish I could figure these valves out. If I just knew the position of the three valves and idle spur gear at idle, I could probaly figure it out.
Really wish I could figure these valves out. If I just knew the position of the three valves and idle spur gear at idle, I could probaly figure it out.
4x4fab.com
- kdxquebec
- Supporting Member II
- Posts: 1255
- Joined: 07:18 am Nov 24 2004
- Country:
- Location: Québec:North Pole
- Contact:
-
- Member
- Posts: 29
- Joined: 12:18 am Apr 09 2009
- Country:
- Location: Hamilton, Ohio