STUPID QUESTION
- KDXforlife
- Member
- Posts: 26
- Joined: 12:44 pm Feb 17 2007
- Country:
- Location: Littleton Co
STUPID QUESTION
I BOUGHT A BIKE AND THE GAS CAP IS BROKEN AND IT LEAKS EVEYWHERE. DOES ANYBODY KNOW HOW MUCH ONE WILL COST. I HAVE A JUNK YARD BY MY HOUSE CAN I JUST STEAL ONE OFF A OLD JUNK YARD BIKE
- canyncarvr
- Gold Member
- Posts: 6943
- Joined: 01:07 pm Nov 05 2004
- Country: US
- Location: The Mythical State of Jefferson
Ron Ayers says $12.00 for an 'H' model cap.
You can get part number/cost information on the whole OEM microfiche there (http://www.ronayers.com).
Re: 'old junk yard bike'?
Sure. Well...assuming you realize that not all caps fit all bikes.
You are sure the tank neck itself is not broken? That is a not uncommon failure.
You can get part number/cost information on the whole OEM microfiche there (http://www.ronayers.com).
Re: 'old junk yard bike'?
Sure. Well...assuming you realize that not all caps fit all bikes.
You are sure the tank neck itself is not broken? That is a not uncommon failure.
Consider the source
Using a perceived level of knowledge to boost my self worth.
Non impediti ratione cogitationis
bike profile: !clicky!
- scheckaet
- KDXRider.net
- Posts: 3740
- Joined: 12:09 am Nov 10 2005
- Country:
- Location: edmond oklahoma
make sure the seal is seated properly too (well if there is one on the oem cap).
I had mine leak a LOT (soaked all the way through my pants nobody smokes around please!) on my IMS tank, then i realized the o ring was not seated right
I had mine leak a LOT (soaked all the way through my pants nobody smokes around please!) on my IMS tank, then i realized the o ring was not seated right
02 KX 200 hybrid: RB head and carb
Sold ☹ DRZ 400 SM
bike build: http://www.kdxrider.net/forums/viewtopi ... ike+stable
bike profile http://www.kdxrider.net/forums/viewtopi ... 0709#30709
newb info: http://www.kdxrider.net/forums/viewtopi ... 57#p117919
jetting guide: http://www.kdxrider.net/forums/viewtopi ... 105&t=1156
Sold ☹ DRZ 400 SM
bike build: http://www.kdxrider.net/forums/viewtopi ... ike+stable
bike profile http://www.kdxrider.net/forums/viewtopi ... 0709#30709
newb info: http://www.kdxrider.net/forums/viewtopi ... 57#p117919
jetting guide: http://www.kdxrider.net/forums/viewtopi ... 105&t=1156
- canyncarvr
- Gold Member
- Posts: 6943
- Joined: 01:07 pm Nov 05 2004
- Country: US
- Location: The Mythical State of Jefferson
There is a gasket on the OEM cap (again..'H' model referenced).
Consider the source
Using a perceived level of knowledge to boost my self worth.
Non impediti ratione cogitationis
bike profile: !clicky!