Cheap reed spacer
Posted: 05:00 pm Dec 04 2006
The topic of reed blocks and spacers seem hot right now, check out the gallery to see what I made at home on the cheap!! 
Page 1 of 1
Posted: 08:25 pm Dec 04 2006
Be a whole lot easier if you just posted the darn pic
Posted: 08:32 pm Dec 04 2006
Please tells us newbees what diffrence that makes.
Posted: 12:36 am Dec 05 2006
NOT a thing ! Dyno says so !
Posted: 09:48 am Dec 05 2006
It did not make a huge difference, not by any means as huge as installing the RB carb. Thanks again, Ron!
By "difference" on the bottom, it seemed that it got the engine into the powerband slightly quicker and had an even better throttle response. The hit came a little sooner with both the CEK and the DEK needle. DEK still being smoother than the CEK, all clip 4. 40/155
I am running the Boyesen 607 reeds as well. Can't say that it makes any more power by numbers, it just felt a little snappier. I have found the SSS with the air screw before and after this mod.
I can say for sure that I am not the machinist Ron is, as he firsthand saw some of my peanut grinding
By "difference" on the bottom, it seemed that it got the engine into the powerband slightly quicker and had an even better throttle response. The hit came a little sooner with both the CEK and the DEK needle. DEK still being smoother than the CEK, all clip 4. 40/155
I am running the Boyesen 607 reeds as well. Can't say that it makes any more power by numbers, it just felt a little snappier. I have found the SSS with the air screw before and after this mod.
I can say for sure that I am not the machinist Ron is, as he firsthand saw some of my peanut grinding