Bearing recommendations

Got questions? We got answers....
User avatar
m0rie
Supporting Member I
Supporting Member I
Posts: 2220
Joined: 10:25 pm Nov 29 2004
Country:
Location: Crescent City, CA

Post by m0rie »

SGM wrote:
canyncarvr wrote:
Point is that PivotWorks bearings are NOT caged/pinned. Now...that's a good thing if you look at it from the length of roller/load point of view. It kinda stinks when it comes to cleaning them. They all fall out!

But it's much easier to clean/pack them well when all the pieces come out. Just don't lose any of the `lil puckers.
How about moose bearings, does anyone know if they are caged/pinned?
They are not caged or pinned. Another thing to note about Moose's Bearing kits. They are actually All Balls bearings which are a cheaper bearing than some i've seen. But with regular greasing they hold up just as well as the pivot works bearings from what i've seen.

-Maurice
Last edited by m0rie on 07:03 pm Feb 25 2005, edited 1 time in total.
1989 KDX 200
2007 TTR-50E
SGM
Member
Posts: 16
Joined: 12:39 pm Feb 03 2005
Country:
Location: The Met. SE MA

Post by SGM »

Thanks
PHTR
SEMRAM2
FFRT
Post Reply