I was practicing steering with my knees as advised on this forum, as I left the bike over the handlebars my knees had another go at it but this time trying the handlebars.
I have managed to pull the handlebar rubber mount through the triple clamp whilst performing this manoeuver.
looking at it, the large washer had been bent over the nut to act as a locking tab so was easily pulled through the rubber handlebar mount as my knees had a go at steering.
I have the manual for the 89 kdx that was not rubber mounted, can someone tell me the torque setting for this nut (the one on the underside of the triple clamp), and is it a lock nut or is bending the washer over what the manual describes?
Thanks
Chris
Handlebar mounts
- quailchaser
- Supporting Member II
- Posts: 485
- Joined: 06:19 pm Feb 24 2005
- Country:
- Location: Phx, AZ
- Contact:
-
- Member
- Posts: 47
- Joined: 01:35 pm Feb 11 2006
- Country:
- quailchaser
- Supporting Member II
- Posts: 485
- Joined: 06:19 pm Feb 24 2005
- Country:
- Location: Phx, AZ
- Contact:
No idea what the torque spec. is? I looked in the KX manual (same set up) and there is no spec. listed. Hmmmm. Scott's and Applied make neoprene (sp?) replacement cones that are more resistant to crushing. I think Fastway makes some alum cones that basically make it a "solid" mount.
I have always tightened them as tight as I could get them with a standard length box/open end wrench. Never had one come loose.
I have always tightened them as tight as I could get them with a standard length box/open end wrench. Never had one come loose.
Robb
*Sold* but not forgotten '03 KDX220R
'02 KX250
PW80 for the Gman
XR50R with Zuk yellow plastic and pink starlet stikers...soon to be Katiebugs ride.
AMA
Off Camber M/C
BRC
AZOHVC
*Sold* but not forgotten '03 KDX220R
'02 KX250
PW80 for the Gman
XR50R with Zuk yellow plastic and pink starlet stikers...soon to be Katiebugs ride.
AMA
Off Camber M/C
BRC
AZOHVC