2003 rear brake light

Got questions? We got answers....

2003 rear brake light

Postby stirfry » 12:21 am Jun 08 2006

used the search and really did not get what i was looking for. Got the pressure switch, now how do you run it into the wiring (electrical) system. :roll:
It,s hard to keep a good dog off your leg. Ted Nugent.
stirfry
Member
 
Posts: 3
Joined: 12:49 am Mar 13 2006
Location: ne okla
Has thanked: 0 time
Been thanked: 0 time

Postby OverTheHill » 02:19 am Jun 08 2006

If using the stock 2 wire taillight, unplug the taillight wire from the red wire behind the air box. Plug in one of the switch wires into the red power wire. Plug the other switch wire into the taillight wire.

If you replaced the taillight or installed an 1157 type plug with 3 wires, plug the switch wire into the brake wire, ground to black, and taillight to red. You need to make a pigtail so that there are 2 plugs at the end of the red wire for the taillight and brake switch.

If you are not sure which is which, use a 12 volt battery to find the brake (brightest) light. Ground is usually black or brown and connected to the body of the socket. This goes to negative on the battery for testing.

Mounting the switch in the brake cylinder will require some spacers (washers) and/or grinding the brake fluid reservoir mount.
OverTheHill
Supporting Member III
Supporting Member III
 
Posts: 19
Joined: 04:24 pm Apr 17 2005
Location: Boise, Idaho
Has thanked: 0 time
Been thanked: 0 time

Postby stirfry » 10:19 am Jun 08 2006

OverTheHill, thanks for the brake info
It,s hard to keep a good dog off your leg. Ted Nugent.
stirfry
Member
 
Posts: 3
Joined: 12:49 am Mar 13 2006
Location: ne okla
Has thanked: 0 time
Been thanked: 0 time

Postby canyncarvr » 12:06 pm Jun 08 2006

>|<>QBB<
OverTheHill wrote:If using the stock 2 wire taillight, unplug the taillight wire from the red wire behind the air box. Plug in one of the switch wires into the red power wire. Plug the other switch wire into the taillight wire.



That gets you a light when you brake, but no taillight.

Is that what you want?

You can use an 1156 (single element) with a resistor wired in series into the ground lead. Run the 'normal' tail signal thru the resistor to ground, connect the pressure switch to the socket side of the resistor, the other switch wire to ground.

Consider the source
Using a perceived level of knowledge to boost my self worth.
Non impediti ratione cogitationis

bike profile: !clicky!
User avatar
canyncarvr
Gold Member
Gold Member
 
Posts: 6941
Images: 26
Joined: 01:07 pm Nov 05 2004
Location: The Mythical State of Jefferson
Has thanked: 0 time
Been thanked: 2 times


Return to KDX General Q&A

Who is online

Users browsing this forum: B.R.S. and 7 guests