Looking for others experiences with FRP cylinder porting, carb bore, and head mill (RB’d)
-
JZ05220r
- Supporting Member II
- Posts: 569
- Joined: 12:36 pm Mar 28 2021
- Country: United States
Looking for others experiences with FRP cylinder porting, carb bore, and head mill (RB’d)
This is regarding my 220. My main concern: Will it still tractor down low? I just want to hear some of your experiences with all FRP mods, his porting and carb boring except it will go with my previously milled RB head and boyeson Rad valve or the stock reed valve with boyeson 607s (I have each on hand) Thank you!
2005 KDX220r 1991 KDX200 2022 KTM 500excf
-
Molly's 70
- Platinum Member
- Posts: 568
- Joined: 04:29 pm Jun 18 2017
- Country: USA
- Location: Wichita, Kansas USA
Re: Looking for others experiences with FRP cylinder porting, carb bore, and head mill (RB’d)
Yes to all.
If you lend someone $20, and never see that person again, it was probably worth it.
-
JZ05220r
- Supporting Member II
- Posts: 569
- Joined: 12:36 pm Mar 28 2021
- Country: United States
Re: Looking for others experiences with FRP cylinder porting, carb bore, and head mill (RB’d)
Thanks these are some things I didn’t ask on the phone.
2005 KDX220r 1991 KDX200 2022 KTM 500excf