Float seat height

[Tiretread13]

Rebuilding my carb and needed a new float seat so i order a new brass one took out the original one with a easy out and i’m just about to install the new one but do not know how far i should press it in , Does anyone have the measurements to the top of the brass float to the lip of where it is pressed in , found picture off internet for reference

[SS109]

To answer your question, or not, sorry, but I don't know. I have never done that before.

Since this is a subforum for website updates, I'm moving this to the "General Q&A" subforum.

[Tiretread13]

Thanks for the reply , maybe someone doing a carb rebuild could do a quick measurement would be really helpful

[Slick_Nick]

Should be flush, but doesn’t matter really. You can always adjust the float tab to get the proper level in the bowl.

[Tiretread13]

yea just want to be accurate because in the picture it looks raised a tiny bit but looks can be deceiving