KDXRIDER.NET

Hi everyone I picked up a 1990 kdx200 last winter has a project and I have no idea but it seems the rear wheel is not sitting right the bike is not has high as should be can anyone tell me where to look or how the linkage is supposed to be hooked up


Sent from my iPhone using Tapatalk

Welcome to kdxrider.net.

I would definitely check all the linkagr bearings to make sure none are binding. It surely looks like it is not setting correctly.

Where would the cheapest place be to get rebuild kits for linkage or what options do I have also going to rebuild swingarm I guess while I got it apart


Sent from my iPhone using Tapatalk

I am not sure where in Canada is cheapest.

It looks like it was setting normally in the "before" picture. What happened? Reassembly error?

It was sitting nice before I took it apart but now it’s not and it’s definitely something stupid I don’t see but I am assuming yes it was reassembly error lol


Sent from my iPhone using Tapatalk

Sometimes a "do over" is cheaper than new parts.

Do anyone have a picture of general layout for me to go by referencing


Sent from my iPhone using Tapatalk

If you do need new parts, in Canada it's almost impossible to beat Fortnine. Great service, returns and free shipping over $49. I use them almost exclusively now.

Guys I have a couple problems noticed a few things missing during reassembly first can anyone snap a pic of how rear brake line is routed also do anyone have the 2 spacers that go into swingarm between the motor


Sent from my iPhone using Tapatalk

The spacers for the swingarm part # 11012-1259 You need 4 of them.