KDXRIDER.NET

Sudco ?

i have replaced the float needle. i looked at the jet block gasket and it seems pretty flattened out. I cannot find anywhere that sells them in Canada. jets r us wont ship here. The guy in the netherlands is out of stock and every dealer pic of the carb doesnt show the gasket. Anyone know where i can get one. This is getting insane .[/quote]

OH FOR HEAVENS SAKE! This is silly. It's only a stupid little O ring. Do you know anyone here in the US that could order one for you and then send it to you?

If not, let me know and I'm sure I can help you with this.

I dont know anyone in the us. Any help would be much appreciated. thanks

You could bite the bullet & ship your carb off to RB designs in Oregon & get him to work his magic on your carb ....at the same time add a note that you want the jet block gasket replaced

Greatbrit, I read your statement on ThumperTalk. Pictures ARE allowed on this site.

Fixed it. redone float. Blew all lines. 145 main. 40 pilot. got mix right. runs mint WHAT A FRIKKIN PALAVA. thanks to everyone for putting up with my annoying posts.

So it was the float? Was it damaged or just the height?

Float was twisted. i set it back to 16mm . then played with the mixture.

Cool. It did look twisted to me in the pics, but I was not sure if it was just camera angle.

Good to hear you got it fixed up and thanks for the update.