Cylinder prep
-
- Supporting Member II
- Posts: 342
- Joined: 11:20 pm Jul 23 2013
- Country:
Cylinder prep
Hi folks, so just what has to be done to the cylinder to prepare for a new piston/rings? There is a lot of conflicting advice I'm seeing so what have you personally done to your cylinder to get it ready? I was planning on scotch brite pads to give it a good cleaning then the old soap and hot water wash and away I go. Any thoughts would be appreciated.
97-220 with a PC pipe. 2015- RB carb and head mod
- KDXGarage
- KDXRider.net
- Posts: 14062
- Joined: 06:45 am Nov 01 2004
- Country: United States of America
- Location: AL, USA
- Contact:
Re: Cylinder prep
If the plating is not worn out then that sounds good to me.
Thank you for participating on kdxrider.net.
To post pictures from a device: viewtopic.php?f=88&t=24128
To post pictures from a device: viewtopic.php?f=88&t=24128
-
- Supporting Member II
- Posts: 342
- Joined: 11:20 pm Jul 23 2013
- Country:
Re: Cylinder prep
Thanks Jason for your input, the plating looks good as far as I can tell. Time to do some scrubbing!
97-220 with a PC pipe. 2015- RB carb and head mod