I planned on doing the shim mod on my forks while I was installing my XR400 springs on new to me 2000 kdx200. Forks are stock as far as I can tell. What valves are these? They look different than what I've seen in other shim mod threads. First the shims are a few different sizes. There's no cup at the top of the assy. And the valve may different itself????? I didn't remove any shims because they were different sizes, and more of them.
Thanks
Fork valve ID...Attempted shim mod
-
- Supporting Member
- Posts: 49
- Joined: 10:29 am Sep 16 2014
- Country: United States
- Location: Tn, USA
Fork valve ID...Attempted shim mod
2000 KDX 200
RB carb mod
FMF rev, power core
Race tech gold valves
RB carb mod
FMF rev, power core
Race tech gold valves
- KDXGarage
- KDXRider.net
- Posts: 14063
- Joined: 06:45 am Nov 01 2004
- Country: United States of America
- Location: AL, USA
- Contact:
Re: Fork valve ID...Attempted shim mod
HEY, ALL RIGHT!! Congratulations, sir. You are now the aware, new owner f some Race Tech Gold Valves.
Thank you for participating on kdxrider.net.
To post pictures from a device: viewtopic.php?f=88&t=24128
To post pictures from a device: viewtopic.php?f=88&t=24128
-
- Supporting Member
- Posts: 49
- Joined: 10:29 am Sep 16 2014
- Country: United States
- Location: Tn, USA
Re: Fork valve ID...Attempted shim mod
Sweet!!!! I'm thinking I need to take my springs to be tested and see what rate they are for the front and rear. The pre-load spacer is about 79mm or 3-1/8" . If the PO put gold valves in I'm sure the it's been resprung in the front and back.
2000 KDX 200
RB carb mod
FMF rev, power core
Race tech gold valves
RB carb mod
FMF rev, power core
Race tech gold valves