KDX Exhaust Mount.
-
- Member
- Posts: 4
- Joined: 10:27 am Feb 21 2014
- Country:
- Location: VT
KDX Exhaust Mount.
Does anyone have an easy or cheap fix for the exhaust mounts?
- diymirage
- Supporting Member II
- Posts: 2909
- Joined: 05:00 pm Sep 19 2011
- Country:
- Location: michigan
Re: KDX Exhaust Mount.
yes
newbbewb wrote:DIYmirage has it right.
-1996 KDX 200 woods weapon (converted to 99 green body)
-1996 KDX 200 plated street toy (barney edition)
-2003 Yamaha TTR125-L (wifeys bike)
-1997 KDX 220 project bike
- diymirage
- Supporting Member II
- Posts: 2909
- Joined: 05:00 pm Sep 19 2011
- Country:
- Location: michigan
Re: KDX Exhaust Mount.
newbbewb wrote:DIYmirage has it right.
-1996 KDX 200 woods weapon (converted to 99 green body)
-1996 KDX 200 plated street toy (barney edition)
-2003 Yamaha TTR125-L (wifeys bike)
-1997 KDX 220 project bike
- Postigo
- Gold Member
- Posts: 372
- Joined: 10:09 pm Aug 12 2012
- Country:
- Location: Puerto Rico
- Contact:
Re: KDX Exhaust Mount.
Clean the rubber with a brush and alcohol and then glue it with super glue (crazy glue). The rubber can be replaced with piece of tire if necessary. You will never buy new mounts again. Hope this helps
The Doctor says I have multiple personality desorder... But we are not agree...
- bufftester
- Platinum Member
- Posts: 3459
- Joined: 06:03 pm Oct 31 2012
- Country: USA
- Location: University Place, WA
Re: KDX Exhaust Mount.
+1 for each of those. My crazy glued mount has been holding for over a year and i have an isolator that is almost 2 years old now
-
- Member
- Posts: 4
- Joined: 10:27 am Feb 21 2014
- Country:
- Location: VT
Re: KDX Exhaust Mount.
Nice, I'm going to try an glue them for now. Thanks for the help.
-
- Supporting Member II
- Posts: 579
- Joined: 12:20 am Jan 22 2012
- Country:
- Location: sw washington state
Re: KDX Exhaust Mount.
I didn't think that glue would hold, thats good to know. I drilled mine and put a nut and bolt through the center of the rubber. I will try glue next time.
-
- Supporting Member II
- Posts: 96
- Joined: 10:28 am Jul 13 2013
- Country:
KDX Exhaust Mount.
. That's what I did. It's been fine ever since.newbbewb wrote:I didn't think that glue would hold, thats good to know. I drilled mine and put a nut and bolt through the center of the rubber. I will try glue next time.