KDXRIDER.NET

Hi

Bought a KDX 250 recently and all the lights worked fine.

Now a few weeks later, the bike still runs fine, but the lights (both front and rear) don't work (intermittedly come on). All I have done is pull the seat and tank off.

I'm not great with electrics, assuming its a loose connection (cannot see anything obvious).

Any ideas on where to focus on if both front and rear lights are out? Is there any known problem spots with the KDX's

Appreciate any advice

Adam

Hi Adam (or Jerry)
not a whole lot of experience with the 250 here but if the wiring is anything like the 200s it has to be dead simple
if it were my bike I would start at the flywheel cover and check the connection on 3 wires coming out of there

maybe even buy a little tube of dielectric grease and put a dab on each connection as you go