Page 1 of 1
220 piston question
Posted: 10:00 am Oct 18 2005
by parker72001
i have a 220 and need to get a wiseco piston still but i was wondering if i need to re-hone the cylinder? if so do i need to take the whole engine out or what, any info would really help
Posted: 01:38 pm Oct 18 2005
by fuzzy
Nope on both. You can get the cyl off w/o removing the motor. You can just 'hone' the cyl with a little scotch-brite.
Posted: 08:06 am Oct 19 2005
by parker72001
thanks a lot
Posted: 08:08 am Oct 19 2005
by Indawoods
Get a manual Parker... it will help you more than asking these type questions. If you run into a problem or don't understand something then ask away!
Posted: 08:12 am Oct 19 2005
by parker72001
i have a manual just didn't look at it, i'm not going to do it right away i was just wondering
Posted: 08:30 am Oct 19 2005
by Indawoods
The manual will show you how to do it.
Posted: 05:10 pm Oct 19 2005
by KDXSean
take the manual to the outhouse with you, read it while your sittin' there
Posted: 01:08 am Oct 20 2005
by skipro3
I have 2 manuals; one in the throne room, the other in the garage. The lighting is better on the throne, so I spend most of my reading time there!!