Shift Lever Adjustment
-
- Member
- Posts: 7
- Joined: 05:45 pm Nov 21 2012
- Country:
Shift Lever Adjustment
I have a 2005 KDX 200, is there any possible way to adjust the height of the stock shift lever.
- diymirage
- Supporting Member II
- Posts: 2909
- Joined: 05:00 pm Sep 19 2011
- Country:
- Location: michigan
Re: Shift Lever Adjustment
undo the pinch bolt, pull it off of the shaft, rotate it to where you want it and put the bolt back in
thats all ther is too it
thats all ther is too it
newbbewb wrote:DIYmirage has it right.
-1996 KDX 200 woods weapon (converted to 99 green body)
-1996 KDX 200 plated street toy (barney edition)
-2003 Yamaha TTR125-L (wifeys bike)
-1997 KDX 220 project bike
-
- Supporting Member III
- Posts: 65
- Joined: 08:24 am Jul 10 2011
- Country:
- Location: G.V. California
Re: Shift Lever Adjustment
I believe I had to file a little bit of the square area off of the outside of the lever where it attatches to the shaft to get my lever where it felt good, will rub on the case if you drop it to low and don't remove some material.
-
- Member
- Posts: 41
- Joined: 05:51 pm Feb 04 2012
- Country:
- Location: New Zealand
Re: Shift Lever Adjustment
skippypinecone wrote:I believe I had to file a little bit of the square area off of the outside of the lever where it attatches to the shaft to get my lever where it felt good, will rub on the case if you drop it to low and don't remove some material.
Same here.