Removing Rear Master Cylinder connector
Posted: 06:40 am Jun 14 2012
Hi guys,
I've noticed that my rear pads are rubbing, so I've decided to clean out the relief port on the master cylinder. However I'm having trouble removing the connector (where the feed from the resevoir fits over) from the master cylinder. I have removed the circlip, but cant remove the connector it self. I'm scared if I pull it to hard it will break. Any tips?
Thanks!
I've noticed that my rear pads are rubbing, so I've decided to clean out the relief port on the master cylinder. However I'm having trouble removing the connector (where the feed from the resevoir fits over) from the master cylinder. I have removed the circlip, but cant remove the connector it self. I'm scared if I pull it to hard it will break. Any tips?
Thanks!