KDXRIDER.NET

i want to put a wider set of pegs on my bike since mine are alittle nutz up. i dont wanna spend 80 bucks on a set of pegs. i was looking at these on ebay but i dont know if they will fit my bike.

http://www.ebay.com/itm/Kawasaki-KX-125 ... da&vxp=mtr

Try reading this and see if it helps any. If not do a search and you will probably find someone that has used them before.

http://kdxrider.net/forums/viewtopic.ph ... egs#p92029

The ones you linked will only fit the H series bikes. Read the thread rbates linked for you and that will get you going in the right direction.

I looked d2moto website and they dont list pegs for an E bike. So it looks like replace with stockers or spend $100 on pegs.

No, there isn't one available for the E series unless you buy IMS pegs. Try this thread: http://kdxrider.net/forums/viewtopic.ph ... light=pegs About half way down the page I tell and show what I did to get wider pegs on my E bike.

Ill check out some yz pegs. How are urs holding up? Would any kx pegs work that anyone kno of?

Mine worked great while I had them on. I took my bike down for a full rebuild to they didn't see a ton of use yet. However, the time I did have them on they worked great and show almost no signs of wear. I do plan on putting them back on my bike when it is done.

No anyone that can weld?

I have an old thread around here about a whole slew of yamaha pegs that fit, and are quite a bit wider than the stock KDX pegs.

Julien D wrote:I have an old thread around here about a whole slew of yamaha pegs that fit, and are quite a bit wider than the stock KDX pegs.

Yep! I linked it above.

lol. Damn I must be getting old or something....

Julien D wrote:lol. Damn I must be getting old or something....

Yeah, that is it. Suuuuure!

Hey, I'm at work. No beers for um.... 45 more minutes!

Julien D wrote:Hey, I'm at work. No beers for um.... 45 more minutes!

Well, before you start doing 12oz curls to improve your physique , please check your PM's.

On ur write up on the pegs u said u couldnt bend them to make them fit in the mount and you had to grind them. I have a small shop press would that work insted of grinding them?

dnovack wrote:On ur write up on the pegs u said u couldnt bend them to make them fit in the mount and you had to grind them. I have a small shop press would that work insted of grinding them?

If your talking to me, no, I don't think a press would do it on the IMS clone pegs. I think all you would succeed in doing is cracking them.