KDXRIDER.NET

Besides the slealer is there a cheap replacement out there somewhere? I didn't get one with my bike. I managed to get it out but prolly a lot easier with the right tool. Thanks guys

I use a standard spark plug socket with the hex on the backside along with a short box end wrench. It works perfectly on my E series. You can get them at just about any autoparts store.

13/16" wrench if my memory is correct.

The H model (maybe E too) is pretty tight around the spark plug so I made a pretty nice wrench by cutting down a 12 point spark plug socket and welding a broken ratchet handle to it. It fits real good and the 12 point makes it easier to tighten and loosen.

I went the easy route and bought a plug wrench from RM ATV. Cheap enough too, if you dont have to pay for shipping, which you dont for orders over $99.

Actually, maybe that makes it the most expensive plug wrench ever.

Anyway I got one at RM.

I got a "waterpumper" MSR wrench with a low profile from dennis kirk years ago, and have used it a ton. It is basically the same thing as what RBates9 made, and it was maybe $8. Look there or RMATV and you should be able to find an inexpensive one to suit your needs.

$1 Harbor Freight 13/16" wrench cut in half. Tighten barely past hand tight, and use anti sieze.

rbates9 wrote:The H model (maybe E too) is pretty tight around the spark plug so I made a pretty nice wrench by cutting down a 12 point spark plug socket and welding a broken ratchet handle to it. It fits real good and the 12 point makes it easier to tighten and loosen.

+1

The PO of my bike made one with a spoke wrench on 1 end. AND gave it to me

For $20.95 Fredette Racing Products sells a wrench that fits your plug, front axle and rear axle.
http://www.frpoffroad.com/FRP-Riders-Wr ... ogId=-1039

Klammer wrote:For $20.95 Fredette Racing Products sells a wrench that fits your plug, front axle and rear axle.
http://www.frpoffroad.com/FRP-Riders-Wr ... ogId=-1039

thats what I use

That is a nice looking tool!

That does look nice, think maybe I'll go with that

Just ordered one from FRP! Thanks guys

I like fuzzy's suggestion. Is there anything available that is:
A. Less than $10
B. Small enough to fit well in the KDX pouch
C. Easily able access the spark plug without taking anything off the bike such as fenders, etc.
D. Doesn't require welding

Oasiscraze wrote:I like fuzzy's suggestion. Is there anything available that is:
A. Less than $10
B. Small enough to fit well in the KDX pouch
C. Easily able access the spark plug without taking anything off the bike such as fenders, etc.
D. Doesn't require welding

MSR (or Pro Motion?) 2T spark plug wrench. I think they are $9

I think I bought my last one at Cycle Gear, but well stocked MC shops will have them on the shelf .