All- balls lower link rebuild kit
-
- Member
- Posts: 743
- Joined: 06:37 am Nov 22 2009
- Country:
- Location: united kingdom
All- balls lower link rebuild kit
just stripped the lower linkage bearings on my 220 & replaced them with all-balls items, have noticed that the new kit comes with x4 thin washers however i`m not too sure as to where these washers belong as my O.E items never had them...has anyone here fitted all-balls bearings to their 200/220 if so where did you fit these washers...i can only think that perhaps x2 go between the lower link bearing & lower swing arm bearing & the remaining x2 fit between the lower frame mount & lower link ??? cant see anything in my workshop manual so perhaps they could be an upgrade of some sort to help keep the crud out of the bearings??
- OLHILLBILLY
- Supporting Member I
- Posts: 286
- Joined: 08:34 pm Feb 10 2009
- Country:
- Location: S. W. Missouri
-
- Member
- Posts: 6
- Joined: 12:42 pm Jul 26 2011
- Country:
- Location: United Kingdom
Hi, the washers you have are used on some models like the Kdx SR.....
As in part no 92025 in this link http://www.megazip.ru/ru/bike/kawasaki/ ... 4471#g4497
But on the 220 diagram they are no longer used.
As in part no 92025 in this link http://www.megazip.ru/ru/bike/kawasaki/ ... 4471#g4497
But on the 220 diagram they are no longer used.
-
- Member
- Posts: 743
- Joined: 06:37 am Nov 22 2009
- Country:
- Location: united kingdom
i managed to squeeze 1 washer between the frame & swingarm bush, this seemed to take up the ever so slight gap but once tightened down the play was non exsistant..the othe 2 washers i placed on 1 of each `bones` ( x1 l/h side & x1 r/h side) again this made the `bones` line up perfect..as someone mentiond before i think you need a fraction of play to allow for assembly & grease/lube.