I'm beginning to reassemble the top end after having the cylinder replated. Which way do the seals for the KIPS main shaft install into the head? Is it with the bottom of the U shaped seal towards the center of the head or towards the outside of the head? I can't remember how they were installed when I removed them.
Part # 92049
Can't wait to get this thing back together and fired up.
KIPS Main Shaft Oil Seal
-
- Supporting Member I
- Posts: 60
- Joined: 01:29 pm Jan 29 2011
- Country: US
- Location: Kauai, Hawaii
KIPS Main Shaft Oil Seal
2017 Husqvarna FE250
-
- Supporting Member I
- Posts: 60
- Joined: 01:29 pm Jan 29 2011
- Country: US
- Location: Kauai, Hawaii
Thank you. The more I thought about this, that's the conclusion I came to, too, but wanted to be sure by asking others. The service manual was no help and I could find no pictures of this online.
I do remember having to pry out the old ones from the center hole, out and the only way to have done that would be if the U shaped side of the seal were towards the outside.
thanks again
I do remember having to pry out the old ones from the center hole, out and the only way to have done that would be if the U shaped side of the seal were towards the outside.
thanks again
2017 Husqvarna FE250