Got questions? We got answers....
ditton
Member
Posts: 77 Joined: 02:58 pm Nov 11 2009
Country:
Post
by ditton » 09:57 pm Mar 15 2011
Hi all.
Just wanted to pass on some info I had been searching for that may help others.
I was looking to do my top end soon and the cylinder bolts have got me to thinking how I can use my torque wrench with my crow-foot wrench ends as it looks like regular sockets cannot be used.
I found this site that lets you choose the torque needed and length of crow-foot and then tells you what you should tune your torque wrench to.
Hope it helps.
Ditton
http://www.belknaptools.com/extcalc.asp
Coop
Supporting Member
Posts: 180 Joined: 03:52 pm Sep 24 2010
Country:
Location: Acme, PA
Post
by Coop » 05:43 am Mar 16 2011
Good stuff.
"Twenty years from now, you will be more disappointed by the things that you didn't do than by the ones you did do" - Mark Twain
2003 KDX200
KDXsg
Member
Posts: 358 Joined: 09:12 pm Nov 30 2009
Country:
Location: Singapore
Post
by KDXsg » 09:56 am Mar 16 2011
are the value in inches, mm or cm? the torque in Nm or ft lb? thanks.
A true KDX customizer!!
rbates9
Supporting Member II
Posts: 3164 Joined: 06:07 pm Apr 27 2010
Country:
Location: UPSTATE New York
Post
by rbates9 » 10:51 am Mar 16 2011
Thanks! I have been looking for something like that.
ditton
Member
Posts: 77 Joined: 02:58 pm Nov 11 2009
Country:
Post
by ditton » 07:50 pm Mar 16 2011
Use the same values. Metric or imperial. Do not mix them up
KDXsg
Member
Posts: 358 Joined: 09:12 pm Nov 30 2009
Country:
Location: Singapore
Post
by KDXsg » 08:10 pm Mar 16 2011
Okie. thanks. great site.
A true KDX customizer!!
KDX Butterfly
Queen B
Posts: 2063 Joined: 05:12 am Aug 04 2007
Country:
Location: Cedar Grove, Tennessee
Post
by KDX Butterfly » 08:12 am Mar 17 2011
I just learned what a torque wrench was back when I first got my KDX from Fuzzy, and Vince was helping me get her rockin'.
This helps a ton!
"If I were just two inches taller, I wouldn't be me." ~KDX Butterfly