KDX Lighting Stator Rewind How-To

Got questions? We got answers....
Post Reply
User avatar
Mayor Brap Brap
Supporting Member
Posts: 266
Joined: 07:33 am Nov 02 2013
Country:
Location: Maine

Re: KDX Lighting Stator Rewind How-To

Post by Mayor Brap Brap »

Question on the yellow wire that needs to be clipped in order to remove the stator from the plate. Do I just put it back on the plate, install it in the engine and solder it right back on? Or can I solder a new wire on and make male/female connectors so I can easily install/remove the stator if necessary? Also, if adding wire, what kind and gauge do I need?
User avatar
Mayor Brap Brap
Supporting Member
Posts: 266
Joined: 07:33 am Nov 02 2013
Country:
Location: Maine

Re: KDX Lighting Stator Rewind How-To

Post by Mayor Brap Brap »

Bump.
Roadhazardguy
Supporting Member II
Supporting Member II
Posts: 302
Joined: 09:18 pm Aug 13 2012
Country:
Location: Canyon Lake Tx

Re: KDX Lighting Stator Rewind How-To

Post by Roadhazardguy »

I would solder it back on, you could put some insulated bullet connectors there but the less connections you have the better. If adding wire go back with the same size copper wire with as many strands as you can find, I think it's 16ga? but check to make sure.
Tony
1988 KDX 200
1980 KD 80
1989 ATK 406
1984 RM 500
1980 KZ 1300
2008 SM450R
Post Reply