I just picked up a 95 200 and noticed that the rear bearings were shot. As I was poking around I also noticed that the caliper carrier had a ton of rotational play where it meets the swingarm. I'm trying to figure out if one of the two is super worn or if I'm missing a piece that fits between the swing arm and carrier. The carrier channel is "c" shaped and the swing arm tab is "t" shaped.
Any input and advice is appreciated.
Joe
rear caliper carrier issue
-
- Supporting Member I
- Posts: 57
- Joined: 04:25 pm Jan 12 2011
- Country:
- frankenschwinn
- Supporting Member II
- Posts: 482
- Joined: 01:20 pm Nov 28 2009
- Country:
- rbates9
- Supporting Member II
- Posts: 3164
- Joined: 06:07 pm Apr 27 2010
- Country:
- Location: UPSTATE New York