Page 1 of 1

Mike in Tennessee

Posted: 09:23 pm Jul 02 2012
by zepplin153
Hello,
I ride a '98 KDX 200.
I did a KLX 300 Fork swap, Ground up restore, and MX Fenders, KX Plate.
I love my bike and wouldnt trade it for anything
If anyone lives near the nashville area hit me up.

My ride, Has a great story too Check out my recent post here http://kdxrider.net/forums/viewtopic.ph ... 95#p117295
Image

Image

-Mike

Mike in Tennessee

Posted: 02:09 am Jul 03 2012
by SS109
Welcome! :partyman:

Mike in Tennessee

Posted: 01:19 pm Jul 03 2012
by CoronasAndChips
Welcome to the site. Digg'n the clean minimum graphics on the bike. I just removed all the stickers on mine except for the rear fender. (tomorrows project)

Mike in Tennessee

Posted: 01:34 pm Jul 03 2012
by Julien D
Welcome to KDXRIDER! Glad you found us. Great looking bike! I'll be in nashville this weekend visiting the in-laws. Unfortunately, I will not have my bike with me...

Re: Mike in Tennessee

Posted: 03:22 pm Jul 03 2012
by diymirage
looks good
only thing i would suggest is a chain ;)

Re: Mike in Tennessee

Posted: 04:08 pm Jul 03 2012
by zepplin153
diymirage wrote:looks good
only thing i would suggest is a chain ;)
attention to detail.. I got it on there right after I took this pic.. Funny thing, I rebuilt it and as soon as I was in a position to see if it would start I did. I cranked it over with my family standing around and it started. after smiling and listening for a min. I put it in gear to check... I PANICKED WHEN IT WENT NOWHERE! My wife said very humbly, "does it have a chain?" I was rather embarrassed. But relieved that I didn't have to tear it apart again..

Mike in Tennessee

Posted: 04:41 pm Jul 03 2012
by diymirage
lol, i can just picture your face when i didnt go anywhere
good thing you kept the little lady around

Mike in Tennessee

Posted: 11:27 pm Jul 06 2012
by KDX Butterfly
the mother-in-law lives in huntingdon. i have an uncle not too far from her (i think).

we need to go to tenn soon.

holler at the hubby: kawboy (http://kdxrider.net/forums/memberlist.p ... rofile&u=4)