At the risk of being excommunicated from the KDX forum I would like to ask a tech question about a TT350 for a friend, if any one has had experience with one of theses or can direct me to a forum. So a rebuild is under way and nearly complete just the clutch side to reassemble after apply some thread seal and torquing a few bolt, I rotated the engine only to hear a click click coming from the rotor, being a magneto/ cdi system the magnetic pick up is situated at approximately one o'clock on the outer edge of the rotor, should the pick up engage to the point of creating noise, I can only think what it would be like under power, any thoughts
Sent from my iPhone using Tapatalk
Another Brand
- jstcraig
- Supporting Member I
- Posts: 144
- Joined: 03:01 am Oct 17 2014
- Country: Australia
- Location: Perth WA AUS T.
-
- Member
- Posts: 86
- Joined: 06:25 pm Jun 04 2016
- Country:
- Location: Eastern Victoria, Australia
Re: Another Brand
The pickup isn't touching is it? It should be silent and adjusted to be around .020" away from the rotor.
- jstcraig
- Supporting Member I
- Posts: 144
- Joined: 03:01 am Oct 17 2014
- Country: Australia
- Location: Perth WA AUS T.
Re: Another Brand
Thankyou that's what I thought, they have to have an air gap like any pickupJL4049 wrote:The pickup isn't touching is it? It should be silent and adjusted to be around .020" away from the rotor.
Cheers
Sent from my iPhone using Tapatalk