Page 1 of 1
Clutch Cover Failure
Posted: 10:35 pm Oct 05 2018
by rungrandpa
The small aluminum part on the clutch cover that the governor shaft comes out of broke around the base. Not sure what happened. Anyone else have this happen? I'm wondering if it's caused by something or just an unusual failure for me. It's on a 1990 KDX 200.
Re: Clutch Cover Failure
Posted: 04:30 am Oct 06 2018
by TheHabitRabbit
Was it running odd before it broke?
Re: Clutch Cover Failure
Posted: 11:21 am Oct 06 2018
by rungrandpa
Not that I noticed.
Re: Clutch Cover Failure
Posted: 06:19 pm Oct 06 2018
by KDXGarage
Where is it cracked??
Re: Clutch Cover Failure
Posted: 08:39 pm Oct 06 2018
by rungrandpa
Around the base. I did a patch job and ordered a clutch cover off e-bay.
Re: Clutch Cover Failure
Posted: 08:45 pm Oct 06 2018
by doakley
I've been riding with a clutch cover I repaired with JB Weld for the last 3 years.
Re: Clutch Cover Failure
Posted: 09:37 pm Oct 06 2018
by rungrandpa
That's what I used. Took it for a quick ride and it seemed fine. I'll put the other cover on this winter.