Page 1 of 1
jetting a 92' KDX 200 with a KDX 220 PWK 33mm carb
Posted: 05:49 am Mar 21 2010
by KDXsg
Hi, i have a 92' KDX 200 SR model running a PE 28 carb. Recently I have a KDX 220 PWK 33mm carb and would like to install it for more power. is it safe to just install the 33mm carb right in. the carb is having 142mj, 42pj, r1173n needle in 3cilp postion. any advises. thanks
Posted: 07:31 am Mar 21 2010
by Julien D
Yeah, I think it will be safe. You'll need to re-jet most certainly, but you won't know which way to go with it until you can put it in and see how it runs.
Posted: 08:25 am Mar 21 2010
by KDXsg
relieve to hear that. hopefully it wont run too lean and siezed. thanks for the infor.
Posted: 08:37 am Mar 21 2010
by Julien D
If it's lean enough to have seizing troubles you'd know right quick. If you warm it up good, give it throttle and it makes a hollow sounding bog, it's too lean to ride.
Posted: 09:45 am Mar 21 2010
by KDXsg
okie, will take note of that. thanks again.