Head stem bearing gap?

Questions and comments about converting to beefier forks..
Post Reply
N8Strine
Member
Posts: 264
Joined: 12:15 pm Jan 19 2008
Country:
Location: York, PA

Head stem bearing gap?

Post by N8Strine »

When I pressed my bearing on the stem there is a small gap in between the bearing and lower tripple clamp is this suppose to be flush? also there is a small ridge on the kdx stem where the bearing would stop. Since the KDX stem is in the kx clamp this ridge is up higher because the thickness of the kx stem is not as much as the kdx so now what?
N8Strine
Member
Posts: 264
Joined: 12:15 pm Jan 19 2008
Country:
Location: York, PA

Post by N8Strine »

I meant thickness of the kx clamp** not stem
Post Reply