Page 1 of 1
What handlebars to use, kx250 front end, 1" risers
Posted: 08:38 pm Oct 05 2015
by actmobmar
Any suggestions on handlebars, 5'8" tall, kx250 front end, 1" risers. Thanks
What handlebars to use, kx250 front end, 1" risers
Posted: 10:14 pm Oct 05 2015
by K50X200
After spending an inordinate amount of time on the Protaper website studying the bar schematic chart and sitting on the bike with a tape measure
, I run a set of Protaper SE Windham/RM Mids...
5'8" tall - KLX300 Fork Conversion - Forks raised in triples 1" w/ Tusk 15mm risers...
Re: What handlebars to use, kx250 front end, 1" risers
Posted: 10:58 pm Oct 05 2015
by 6 Riders
I second the Windhams, second choice are Carmichaels, 3rd choice is YZ high bend.
Re: What handlebars to use, kx250 front end, 1" risers
Posted: 07:00 am Oct 06 2015
by G22inSC
K50X200 wrote: I run a set of Protaper SE Windham/RM Mid...
Exact same bend I use; however, I think bar choice is very personal/unique and would never say "you'll like this bend because I do."
Re: What handlebars to use, kx250 front end, 1
Posted: 08:37 am Oct 06 2015
by K50X200
G22inSC wrote: "I think bar choice is very personal/unique "
Yep! as I was writing my reply I was thinking this thread could start to look like one that's about 2T oil and mix ratios
What handlebars to use, kx250 front end, 1" risers
Posted: 06:03 pm Oct 06 2015
by actmobmar
Thanks guys, ordered a set of Carmichael s